8/2/2023 0 Comments Internal mixer camtwist![]() ![]() It’s that easy! The lower half of the breakaway is also sold separately so you can have a complete hose, nozzle and swivel assembly ready at all times. After inspection, align the two halves together, and let the magnets do the work while pushing the unit back together. With the CAM TWIST™ magnetic ‘snap-back technology’, alignment and reconnection is easy. The unique design seals the internal components before separation is complete, thus reducing any exposure to product. To inspect the unit, two wrenches applied to opposite ends of the breakaway with a twisting motion mechanically separates the unit. The breakaway is designed to be installed between the fuel dispenser and the nozzle. Additionally, durable plastic covers prevent damage during a drive-off while decreasing maintenance and increasing security. After a drive-off, inspect the O-ring surface, lubricate the O-ring surface, align the two halves and then push the unit back together. With the breakaway, there is no need to drain assemblies to change a nozzle. In the Studiocode Capture Window you will need to select Line In as the audio source.The CAM TWIST™ gives you the assurance that your breakaway will perform when you need it most. The Catlow breakaway gives you the option to easily disconnect, inspect and reconnect while installed. This will send the audio out from CamTwist, and right back into Studiocode.ĭ. Connect one end to the headphone jack on the Mac, and the other end to the Line in port. ![]() Use a cable that has a headphone connection (3.5mm) on both ends. Apple menu > System Preferences > Sound > Input.Ĭ. *Note: If you need sound for your video it is important to go to do the following:Ī. Open Capture Window in Studiocode and initiate capture. Launch Studiocode (please note that if Studiocode was currently open you will need to quit out of Studiocode and re-open it).ġ0. In the Settings Column you will want to Confine to Application Window and Filter Out Untitled Windows (see pic)ĩ. Set CamTwist by double clicking on "Desktop +" in the first column.Ĩ. Under the General Tab make sure your Frame Rate is set to 30 FPS and your video size is set to 720x480 (or size that is consistent with your capture settings)ħ. Thus, after CamTwist is set up, you can open a Studiocode capture window and it will see the CamTwist recording as a video source to capture. The basic concept is that CamTwist will make a screen recording of the video/window you tell it to, and simultaneously essentially trick the Mac into believing that same feed is coming in through the thunderbolt port. ![]() It is not the best product if you want to make a screen recording of the web browser to code in a post-capture environment (e.g. in a web browser) that cannot be downloaded. If you don't have a Vosaic account, you can get started with a free trial.ĬamTwist is a product that can be used in situations where you would like to live-code a streaming video online (e.g. IMPORTANT: We can only provide help and support to users of Vosaic's video feedback & analysis platform that allows you to easily record, upload, mark-up or code videos for professional development and research. NOTE: Beginning December 31st, 2017, development of Studiocode and iCoda will stop and new licenses will not be available for purchase. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |